Prusa i3 mk3s的擠壓球腳

I found that there is well known idea to use squash ball for 3d printer feet for anti vibration. I made this model for my Prusa i3 mk3 by myself, so this is not really a remix but pretty much ipired by existing nice desig such as I use "Double yellow dots (softest?)" balls and it works well so far. You will need 4 sets of T-slot nuts and M5x12 bolts to fix them on the frame. There is 45 degrees overhang but was OK to print without support. *Please note when you use this for rear-left corner (where PSU locates), you will have to relocate the PSU. I will post a brace for PSU replacement, but some othe also should work out. [In Japanese] 我知道了為了防止3D打印機的振動而把壁球放在腳上的想法，于是制作了Plua i 3mk3用的這個模型。雖然不是現有模型的混音 等出色的設計成為了參考。 “黃色2點（最軟？”雖然使用了球，但現在感覺不錯。 為了固定到框架上，需要4個T槽螺母和M5×12螺栓。 有45度的突出度，不過，沒有支持打印完成了。 注意：在左后方（有PSU的地方）使用時，需要轉移PSU。 PSU移設時用的刀片也預定投稿，不過，我想其他的設計也OK。