圖片
迪威網友4c9878
免費，登錄即可下載
發布時間：2020/9/19 10:29:00
My fit contribution on Thingivee and fit design. This is a 3D printed USB Power bank based on MakerHawk 18650-Board (H961-U v3):
Adapted a touch seor itead of the build in tactile switch of the board to display charge info. Used this touch seor:
The bottom of the case is designed to hold 6 18650 cells (more could be packet it). In my case, I used 6 old laptop cells and connected them in parallel (as the board specifies).
The top and bottom parts combine using clamping pressure. Caution here as once put together may be difficult to take apart.
IMPORTANT:
I have not designed any side openings for the board tactile switch or the Lightning opening as in my situation, they are not used.
Video of touch:
Adapted a touch seor itead of the build in tactile switch of the board to display charge info. Used this touch seor:
The bottom of the case is designed to hold 6 18650 cells (more could be packet it). In my case, I used 6 old laptop cells and connected them in parallel (as the board specifies).
The top and bottom parts combine using clamping pressure. Caution here as once put together may be difficult to take apart.
IMPORTANT:
I have not designed any side openings for the board tactile switch or the Lightning opening as in my situation, they are not used.
Video of touch:
|
共0個文件
壓縮包大?。?67KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付